Warning: In the event of replacement of any one of the following components: - Operator panel assembly - RIP card assembly
Replace only one component at a time. Replace the required component, and perform a POR before replacing a second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never replace two or more of the components listed above without a POR after installing each one or the printer will be rendered inoperable. Warning: Never install and remove components listed above as a method of troubleshooting components. Once a component has been installed in a machine, it cannot be used in another machine. It must be returned to the manufacturer.
includes: - Media feed unit drive gear 13T - Media feed unit drive gear 28/21T - Media feed unit drive gear 29T - Media feed unit drive gear 27T - 2 mm washer (2 each)
Note: Assembly index items 17 and 18 are identical sensors with different functions; therefore, they are the same part number with different descriptions.
includes: - Media end guide actuator - Actuator link Note: The graphic on the previous page, shows two #7 callouts. These callouts are the two items that make up the media tray end guide actuator kit.
Warning: In the event of replacement of any one of the following components: - Operator panel assembly - RIP card assembly
Replace only one component at a time. Replace the required component, and perform a POR before replacing a second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never replace two or more of the components listed above without a POR after installing each one or the printer will be rendered inoperable.Warning: Never install and remove components listed above as a method of troubleshooting components. Once a component has been installed in a machine, it cannot be used in another machine. It must be returned to the manufacturer.